Pirate 4x4 banner
1 - 10 of 10 Posts

·
Registered
Joined
·
12,238 Posts
Discussion Starter · #1 ·
for all ya spring over guys and early case's (coarse spline - square flange) we are making a new 41 degree joint for this application - what do ya think? Jess
<IMG SRC="smilies/glasses.gif" border="0">
 

·
Registered
Joined
·
120 Posts
Looks good to me. Too bad I went to d44/d60 combo or I coulda went that route. Once I get my T-case doubler and get actual dimensions I'll be contacting you for some new D-shafts.
 

·
Registered
Joined
·
350 Posts
I think I'm gunna need one of those, how much for one with a 13" slip?

never mind, caught it in a another post.

[ 10-23-2001: Message edited by: KeithF ]
 

·
Registered
Joined
·
12,238 Posts
Discussion Starter · #10 ·
i don't like the way 1310 holds up- its cast iron and max angle is 30 degree's not enough for most- and if you grind its even worse for 1310- this newer style is all steel and stronger and no grinding is required to get 41 degree's - Jess
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top