Pirate 4x4 banner
1 - 3 of 3 Posts

·
Registered
Joined
·
230 Posts
Discussion Starter · #1 ·
I need to change the intakes for clearence reasons in the EB when I install my 86 f150 motor. Do I need to change the both the upper and lower intakes or just the upper, and is there any different wireing on the mustang intake that will need to be changed. Also can I reuse the rail fuel pump or do you suggest an aftermarket fuel pump thanks:confused:
 

·
Registered
Joined
·
230 Posts
Discussion Starter · #3 ·
oops

uh that would be, What is a 302/5.0 Alex?:D
 

·
Registered
Joined
·
230 Posts
Discussion Starter · #7 ·
i have to work with what ive got

At this time I have an 86 f150 302 and My buddy has the whole upper and lower intakes ( tb and stuff ) from a mustang but i dont think they are HO. Also will I have to use the mustang injectors ? What are the problems that will arise from swapping the intakes from motor to motor? will it run bad or just slightly less power from the swap? If it is going to incompatable and run like crap I will go ahead and put the hood scoop on but that is not the look that i was going for. I just was hoping to swap the intakes and TB stuff and drop the whole thing in. as you were saying about the lower intake shold i work on it if i reuse it ?
 
1 - 3 of 3 Posts
Top