[ckolloff]

Building quarters:

Somebody with a stock or even close to stock body. I need the height of the rear corner panel from the bottom of the sheet metal to the start of the recess for the hard top. Could you take the measurement at two places: 1-at the rear bumper just before the start of the radius, and 2- just after that radius on the flat bofore the wheel well.

Thanks

 

[FIXXXXAH]

IF NO ONE'S GOT YA BY THE TIME I GET HOME IN A FEW HOURS I'LL MEASURE FOR YA. YOU WANT FROM THE SECTION ABOVE THE REAR BUMPER TO THE START OF THE LIP FOR THE HARD TOP, AND FROM THE SECTION BEHIND THE WHEEL WELL AND BEFORE THE CURVE STARTS, RIGHT?

 

[ckolloff]

Thanks Fixxxah, I measured several at our local TLCA chapter meeting, I hadn't planned on going but not a bad thing to "have to" do.