Pirate 4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
838 Posts
Discussion Starter · #1 ·
Building quarters:

Somebody with a stock or even close to stock body. I need the height of the rear corner panel from the bottom of the sheet metal to the start of the recess for the hard top. Could you take the measurement at two places: 1-at the rear bumper just before the start of the radius, and 2- just after that radius on the flat bofore the wheel well.

:D Thanks:D
 

·
Registered
Joined
·
838 Posts
Discussion Starter · #3 ·
Thanks Fixxxah, I measured several at our local TLCA chapter meeting, I hadn't planned on going but not a bad thing to "have to" do.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top