Pirate 4x4 banner
1 - 5 of 5 Posts

·
Registered
Joined
·
175 Posts
Discussion Starter · #1 ·
Well the scout is finally in the shop getting the full width 1 tons installed. Planning on moving front axle 2 inches forward and the rear 3 inches back. Going to run 39.5 TSL's on 17" rims. Already wondering how much fender I'll have to cut out... Post up pics of your trimmed fenders for ideas. Thanks- Charlie
 

·
Registered
Joined
·
3,938 Posts
scout_on_38s said:
Well the scout is finally in the shop getting the full width 1 tons installed. Planning on moving front axle 2 inches forward and the rear 3 inches back. Going to run 39.5 TSL's on 17" rims. Already wondering how much fender I'll have to cut out... Post up pics of your trimmed fenders for ideas. Thanks- Charlie
5" gain of wheel base isnt enough for 39's IMO.
 

·
Registered
Joined
·
4,690 Posts
Prepare to loose your rear wheel wells, in the pic it is sitting higher then I like, I'm in the process of completing the rear 4 link, the front is 1 1/2" lower and the rear is now 3-4" lower. WB is now 110"

 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top