Pirate 4x4 banner
1 - 5 of 5 Posts

· Registered
1,056 Posts
Discussion Starter · #1 ·
OK, just a trial here but I need a very specific set of shafts for a FF 60. I need them from a 69-72 Chevy/GMC 3/4 ton truck or Suburban. They will be 30 spline and have the smaller diameter flange mounting pattern (3 23/32"). They measure 35 1/8" long for both sides too.

I know it's a long shot, but I figured I gotta try before I start cuttin and weldin.

1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.