Finally bought a axle to swap!!!! Muahahah

755 Views 5 Replies 4 Participants Last post by Codeman, Sep 10, 2001

Codeman

Discussion Starter · Sep 7, 2001

After doing some research and reading several posts arguing Dana 44 vs Ford 8.8, I finally picked up an 8.8 today, 31 splines with disks!!! Much better than my POS Dana 34C.

Yea I know, its not a 60 <IMG SRC="smilies/rolleyes.gif" border="0">. But it should hold up nicely with 35s while I'm at college the next few years.

So if any of you wanna come on down to Texas and help me install it, your more then welcome hehe <IMG SRC="smilies/biggrin.gif" border="0">

[ 09-07-2001: Message edited by: Codeman ]

Save

1 - 2 of 6 Posts

Codeman

Discussion Starter · #6 · Sep 10, 2001

Nah it wasn't bad at all...Poor Flem probably had to do more then he bargined for though lol.

Man, you should have seen my 35C housing...I was about to have some serious problems.

Now all thats left is I'm going to replace the rotors (one was about 1/8" thick), brake pads, and tie in the rear brake lines.

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month