I'm going to be doing the rear soa on mine this weekend. And I gotta find out who has the whored out community torch. Making spring perches with a grinder sucks.
Finally bought a axle to swap!!!! Muahahah
After doing some research and reading several posts arguing Dana 44 vs Ford 8.8, I finally picked up an 8.8 today, 31 splines with disks!!! Much better than my POS Dana 34C.
Yea I know, its not a 60 <IMG SRC="smilies/rolleyes.gif" border="0">. But it should hold up nicely with 35s while I'm at college the next few years.
So if any of you wanna come on down to Texas and help me install it, your more then welcome hehe <IMG SRC="smilies/biggrin.gif" border="0">
[ 09-07-2001: Message edited by: Codeman ]
Yea I know, its not a 60 <IMG SRC="smilies/rolleyes.gif" border="0">. But it should hold up nicely with 35s while I'm at college the next few years.
So if any of you wanna come on down to Texas and help me install it, your more then welcome hehe <IMG SRC="smilies/biggrin.gif" border="0">
[ 09-07-2001: Message edited by: Codeman ]
1 - 2 of 6 Posts
It's going good so far, even the spring perches are damn near bolt up, just had to weld the stock hole and drill a new one a little farther out.
1 - 2 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Pirate 4x4
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!
Full Forum Listing
Top Contributors this Month
View All
Wontun Splodies
79 Replies
total newb
55 Replies
Beat95YJ
45 Replies
Recommended Communities
