Pirate 4x4 banner
1 - 12 of 12 Posts

·
Registered
Joined
·
3,527 Posts
Discussion Starter · #1 ·

·
Registered
Joined
·
2,833 Posts
for the seat belt, if you are not looking for one that says "land cruiser" on the little white sewn on label, the ones out of mid-late 70's toyota pickup trucks are the same...that is what I have in my 1976 fj40. even the bolts for the swivel thing on the cab pillar(roll bar on the fj40) and the floor mount will work in the cruiser.

-Brett

p.s. dont for get to pull a few extra of the bolts that hold the retractor to the body. these are the same odd 11mm thread that the rollbar on the fj40 needs for the jumpseat seat belts.
 

·
Registered
Joined
·
3,527 Posts
Discussion Starter · #3 ·
Thanks for the idea... I'll hit up the wrecking yards tomorrow and see if I can find something.

But if someone does have one, let me know..

:D
 

·
Registered
Joined
·
3,527 Posts
Discussion Starter · #4 ·

·
Registered
Joined
·
1,164 Posts
I think I've got the seat belt from my '76, I'll have to look.

I checked, I don't. I thought I did but after closer inspection they are actually jump seat belts that the previous owner had been using as front seat belts. I pulled them and went with a 4pt harness not long after I bought it.
 

·
Registered
Joined
·
2,833 Posts
cruiseroutfit said:
Another thing I need, the "condenser" type deal that plugs into the voltage regulator on a 76' era FJ40. Thanks in advance...

http://www.pirate4x4.com/forum/showthread.php?s=&threadid=127499

:D;)
not sure which of the following p/n's you will need but:
7601-8007 fj40 90980-04021
7501-7601 fj40 90980-04033
7209-7601 fj40 90980-04011

all are good numbers in my price guide, but all are about $10-16 dealer cost.
 

·
Registered
Joined
·
5,687 Posts
cruiserbrett said:
dont for get to pull a few extra of the bolts that hold the retractor to the body. these are the same odd 11mm thread that the rollbar on the fj40 needs for the jumpseat seat belts.

Hmmm... need to look, but the DOT requirements specified SAE hardware... Seat belt bolts are common SAE 7/16" fine thread, bolts may have an metric head. :D

Tom :usa:
 

·
Registered
Joined
·
3,527 Posts
Discussion Starter · #10 ·
cruiserbrett said:
...not sure which of the following p/n's you will need but:...
You Rule! ;) Thanks
 

·
Registered
Joined
·
3,527 Posts
Discussion Starter · #11 ·
Gunmetalcruz said:
...happy to work something fair out. Tom
Thanks, I'll let you know... ;)
 

·
Registered
Joined
·
1,732 Posts
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top