Pirate 4x4 banner

1 - 4 of 4 Posts

·
Registered
Joined
·
283 Posts
Discussion Starter #1
stupid question but do the raised parts at each hole in the flexplate for the torque converter face out towards the transmission or inward toward the engine?
Im assuming they face out because the counter weight on the flex plate should be facing towards the engine, correct?

sorry for the question but all the info i could find were on high performance ones that weren't stamped out
 

·
Registered
Joined
·
8,377 Posts
Also, if you look at the center hole one side will have a sharp edge and the other will have a radius. The radius edge goes on first on the crank to match
 

·
Registered
Joined
·
311 Posts
An easier way to tell is the ring gear for the starter. The Beveled side of the teeth should face the same side the starter is on.

jim
 
1 - 4 of 4 Posts
Top