Pirate 4x4 banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
2,796 Posts
Discussion Starter · #1 ·
Finally got my front seats so it's time for the floor to go in. I know that most everybody uses 1" square tubing but what wall thickness is it? .125? Hope to get some new update pictures up next week.
 

·
Registered
Joined
·
8,128 Posts
you don't need much to hold up a floor. My new setup is only supported on the edges and in the middle and was made from 12 g aluminum. Angle iron has alot of support with minimal weight.
 

·
Not a Wenzelite
Joined
·
36,551 Posts
you don't need much to hold up a floor. My new setup is only supported on the edges and in the middle and was made from 12 g aluminum. Angle iron has alot of support with minimal weight.
Cool....good to know!
 

·
Premium Member
Joined
·
2,796 Posts
Discussion Starter · #5 ·
Thanks for the info, I have some 2"x3" .125 tubing I'm going to use for my seat mounts and drive shaft loop and I'll go lighter for the rest.
 
1 - 5 of 5 Posts
Top