Pirate 4x4 banner
1 - 2 of 11 Posts

· Registered
612 Posts
Am I missing something here? :confused: You are taking about the flange on the end of the shaft right?
Why not cut down the OD of the flange a little so the rotor will fit. Take it to a machine shop or get a buddy to spin it while you hit it with a grinder.

Yes the wheel hub (fit inside) to rotor clearance.

Why grind or machine if you can find rotors that fit to begin with? :flipoff2:

Grinding or machining is plan B.

That's why I asked.

Do you know the answer to my original question?

(sorry for the hijack, it was a simple quick question)
1 - 2 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.