Pirate 4x4 banner
1 - 9 of 9 Posts

· Registered
862 Posts
Discussion Starter · #1 · (Edited)
I have 3 sets of Ford D60 kingpin knuckles. Also have 1 extra left hand knuckle.

The bottom set are off of a snowfighter axle. These will need the spindle hole opened up to accept a normal Ford spindle. They just need to be cleaned up, machined and are good to run after that.

The single drivers side knuckle. It is cracked, but could be repaired if somebody wanted to.

Full sized pictures can be seen at

$30 for the snow fighters
$10 for the remaining drivers side
Located in Corpus Christi Texas 78414

1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.