Pirate 4x4 banner

1 - 5 of 5 Posts

·
Premium Member
Joined
·
12,586 Posts
Discussion Starter #1
Hey, ya'll. I'm not really a Yota guy, although I do post in here often about what I do know. (Sometimes what I dont'.) I also drive a 4Runner as my daily driver. (I drive my Jeep off road.)

Anyway, I'm sure this has been asked before but it didn't turn up under a few different searches that I've done, so here it goes:

What are the dimensions on a solid front axle shaft? I need to know the inner and outer diameters, and inner and outer spline counts. I would also like to know the outside diamter of the axle tube. Thanks.

J. J.

[ 08-29-2001: Message edited by: patooyee ]

[ 08-29-2001: Message edited by: patooyee ]
 

·
Premium Member
Joined
·
11,333 Posts
30sp @ each end, so whatever a 30sp is 1.36? i wanna say, and the housing is 3in <IMG SRC="smilies/smile.gif" border="0"> hope this helps
 

·
Premium Member
Joined
·
12,586 Posts
Discussion Starter #3
It does, thanks. If anyone has any more exact dimesions on the shaft diameter it is appreciated.

J. J.
 

·
Registered
Joined
·
653 Posts
Originally posted by patooyee:
<STRONG>Also, what are the dimensions for the rear shafts?

J. J.</STRONG>
The Toyota rear shaft is on the left. These measurements were made by myself and should be within ±.005". FWIW the shaft on the right is a Moser 31-spline 9" Ford.



[ 08-29-2001: Message edited by: toy283 ]
 
1 - 5 of 5 Posts
Top