Pirate 4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,071 Posts
Discussion Starter · #1 ·
ok

Just got done welding my spider gears in my YJ Dana30

Everything went well and i am very please with the outcome

The one problem we had was the welds blocked the C Clip for the intermediate shaft from going on. i took a close look at this and couldnt figure out the purpose of this c clip.

The FSM calls it a retaining clip but it seems the outer shaft seats into the inner shaft fairly tight and holds it in place nicely.

Am i missing something here?

Is the C clip only there to hold it in place when the outer shaft is removed?

I have 3 outer shafts as spares so that is not a concern if one breaks

Anyone??

thanks
 

·
Registered
Joined
·
1,071 Posts
Discussion Starter · #3 ·
Originally posted by Bugeater:
<STRONG>On my 91 the d30 had no c-clip o that.</STRONG>
you sure?

it is inside the diff on the side of the spider gears

i don't see a purpose for it though

thanks

[ 10-06-2001: Message edited by: Boston Mangler ]
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top