[joe_out_west]

are front ifs drive shaft cv's strong enough to be used in rear shafts?

 

[wes]

YES I have been using one for a couple years with probqably 20 trips into the Rubicon but make sure your pinion is pointing at the transfer case, or within a degree or so, to take full advantage of the CV

 

[Chad]

I'm running one on mine also. With the 7" Skyjacker springs, the driveline had some pretty bad vibrations. Had Jesse at High Angle Driveline put a shaft together for me with the CV in it and it eliminated all vibrations!!! Damn he is good!!!

I run a hybrid with rear Detroit & F&R 5.29's and never had a problem.

 

[stf0412]

Chad,

What do you mean when you say hybrid rear axle? If you are still using the toy third(F&R 5.29's) then are the shafts,brakes different?

 

[Chad]

Sorry...the hybrid is my motor. 22R bottom end with ported & polished 20R head. I'm running around 150 hp. I was just saying that with all the stuff I have done to my engine and driveline, I have never had a problem.