Pirate 4x4 banner
1 - 5 of 5 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
I am doing a Solid axle swap on my Toyota.. I have a 5.29 Rear gear ratio.. I am installing a Dana 44 front axle and the closest I can get to that is a 5.38.. Will this hurt anything? I have checked on mismatching tire sizes to make this conversion work (I haven't purchased my tires yet) and I find that the difference in tire size that it will need to be is less than 1".. This don't seem enough to hurt anything, "if I run the same size tires"... IS IT???
Thanks in advance!!!
 

·
Super Moderator
'82 Scrambler, '14 Rzr
Joined
·
62,014 Posts
1. Why didn't you ask this in the TOYOTA board?

2. Why didn't you SEARCH the Toyota board first (it HAS been covered before).
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #3 ·
I Did post it there, I didn't get a response... This is not TOYOTA question though, it is a gear ratio question.. SORRY, I haven't seen EVERY posted question on this site....
 

·
Super Moderator
'82 Scrambler, '14 Rzr
Joined
·
62,014 Posts
CaptScott5 said:
I Did post it there, I didn't get a response... This is not TOYOTA question though, it is a gear ratio question.. SORRY, I haven't seen EVERY posted question on this site....
You didn't give me time to see it there and reply ;)
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #5 ·
Thanks, Dave!!
That site helped... I now know that this is O.K.!!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top