Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
I am working on a Dana 60 rear from a 1976 F250. It is a face milled ring gear, 410 ratio. I have followed the procedures above however I am all the way down to no shims in the inner pinion race with a .006 backlash and the pattern still shows the pinion should be moved away. Any thoughts?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top