It's hard to search info when the market for these has changed so much.
Looking for a rebuild able link end. Not a fan of snap ring style, dealt with Johnny joints in the past and they're a royal pain to assemble imo.
Also would like to use 7/8 w/ stud and 1 1/4 with stud and without from the...
Hi guys I have a tube chassis drawn up in bendtech. I used to use solidworks a while ago but prefer the ease of drawing tube chassis in bendtech pro.
Can I load the bendtech chassis in solidworks to load in the engine, axles etc so I can cycle suspension for clearance check etc?
I tore up my intermediate shaft bearings and need to rebuild my transfer case. It seems the faces where the intermediate shaft thrust washers rest got a bit chewed up. Do I need a whole new case? or can I clean these surfaces up and send it?
NOTE: there is still dirt/grease on the case...
I have a kingpin 60 and one of the wheel studs isn’t tight enough to keep from spinning. I’ve replaced the stud and it grips but not tight enough. Does anyone have a solution other than changing the hub?
Sent from my iPhone using Tapatalk
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!