Pirate is without a doubt the best off road site on the net and theres alot of real good buildup threads on here. For everyones amusement
lets see the best examples of how not to do it.
This one came from a local lot-
This is another one from the same lot
I tore up my intermediate shaft bearings and need to rebuild my transfer case. It seems the faces where the intermediate shaft thrust washers rest got a bit chewed up. Do I need a whole new case? or can I clean these surfaces up and send it?
NOTE: there is still dirt/grease on the case...
I have a kingpin 60 and one of the wheel studs isn’t tight enough to keep from spinning. I’ve replaced the stud and it grips but not tight enough. Does anyone have a solution other than changing the hub?
Sent from my iPhone using Tapatalk
Okay. I know I must be overlooking something blatant, and am about to get flamed. And no, I am not building one. :flipoff2:
But how come you can run a triangulated 4 link with just the uppers or just the lowers triangulated, but not a 3 link? In the triangulated 4 link, only the two...
I started a thread awhile ago about how I was gonna race my rock lizard chassis, then plans changed about 5000 times, so figured I'd start a new thread now that I'm actually working on it (can read all those ideas and the very beginning of the lizard here...
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!