Pirate 4x4 banner

1 - 4 of 4 Posts

·
Vendor
Joined
·
3,744 Posts
Discussion Starter #1
I am looking for a bulkhead set up for my heater hoses. I would like a plate to bolt through the firewall for two 5/8" hoses to clamp on each side. Any one know of any good junkyard doners or aftermarkets suppliers. vintage air has one that uses threaded fittings but is too much money to spend on this.
 

·
Registered
Joined
·
4,428 Posts
Not sure if they are the right size, but I believe Pontiac Grand Ams have that setup. Probably a late 80s or early 90s, because I remember helping a roommate with a heater core back in the college daze; and I'm almost sure it had that setup.
 

·
Vendor
Joined
·
3,744 Posts
Discussion Starter #4
JohnnyJ said:
Not sure if they are the right size, but I believe Pontiac Grand Ams have that setup. Probably a late 80s or early 90s, because I remember helping a roommate with a heater core back in the college daze; and I'm almost sure it had that setup.
Thanks, that is the kind of info I was looking for. I'll just have to browse through PYP this weekend.
 
1 - 4 of 4 Posts
Top