Pirate 4x4 banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,024 Posts
Discussion Starter #1
OK, I ordered AllPros High Steer kit and am putting it on right now. My question is about the reinforcing plate. Where does it go? My logic says it goes on the inside of the frame, but their instructions say nothing about it and its placement. Anyone got a Pic of this thing where it needs to be? I probably could figure it out, but I figured I would ask first. Don't Flame me!
Heres the a pic of the piece I am talking about. TIA

 

·
Premium Member
Joined
·
2,154 Posts
It goes on the inside of the frame. Once you drill the holes through the frame it is an easy placement on the inside of the frame. Basically the flat short edge goes to the front of the frame and the angled edge goes to the back with the notch out of the botom. It lined up perfectly with the bend in my frame. Hope it helps.
 

·
Wicked Raciest !
Joined
·
17,738 Posts
Inside, that is why the holes are so big. To go over the tubes and welds on the inside of the frame. Did you check the install instructions on their web site??
<IMG SRC="smilies/usa.gif" border="0"> <IMG SRC="smilies/usa.gif" border="0"> <IMG SRC="smilies/usa.gif" border="0"> <IMG SRC="smilies/usa.gif" border="0"> <IMG SRC="smilies/usa.gif" border="0">

[ 10-01-2001: Message edited by: OOPS ]
 

·
Registered
Joined
·
1,024 Posts
Discussion Starter #4
Thanks guys. Its nice to be able to ask folks who have "been there". I'll get back to wrenchin & welding! <IMG SRC="smilies/beer.gif" border="0"> <IMG SRC="smilies/beer.gif" border="0"> On me....
 
1 - 4 of 4 Posts
Top