Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
484 Posts
Discussion Starter · #1 · (Edited)
Coil SAS front end q's?

How thick of wall tubing are people using for multilinks or a radius arm setup for coils? Then the next question is do I run heim joints or should I run poly bushing sleeves?
I have some fabrication skills not alot but I have access to the stuff I need to make this stuff myself. I need some input from people that have done like coils and coilover sas.
What type of setup is going to give me a decent offroad ride and ok the road as well? Lots of pics would help because I have no friggen clue where to start?
I was thinking of using XJ coils to SAS it but my buddy Damien suggested to go with coilovers instead the only issue I have with that is they cost a crapload of dough.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.