Pirate 4x4 banner

1 - 10 of 10 Posts

·
Registered
Joined
·
240 Posts
Discussion Starter #6
monkeyevil said:
I would venture a guess those are NOT Yukon gears :D

That is a textbook pattern.... better than you actualy see in most textbooks :rofl:

actually they are from yukon....not sure if they are actually made by them though..ha

the ring gear says "G5 YG D-44R-513R 304" on it.

i would assume the YG is for yukon gear.

but your right, my last set of yukon's in my 8.8 took forever and never ended up perfect.
 

·
Registered
Joined
·
1,693 Posts
trailxj said:
actually they are from yukon....not sure if they are actually made by them though..ha

the ring gear says "G5 YG D-44R-513R 304" on it.

i would assume the YG is for yukon gear.

but your right, my last set of yukon's in my 8.8 took forever and never ended up perfect.
I had a set the other day that had 4 different patterns on 4 different teeth :shaking:
 

·
Registered
Joined
·
5,465 Posts
Thats a good pattern only if your backlash is within the required limits. I set up a buddies hp44 with ARB and Dana 4.10 gears last night. They setup so nice.
 

·
Registered
Joined
·
1,676 Posts
I am going to jump off the wagon and call it a hair deep. Mostly seen on the coast side.

If it's not a daily driver? Run it.
 

·
Registered
Joined
·
38,247 Posts
pcoplin said:
I am going to jump off the wagon and call it a hair deep. Mostly seen on the coast side.
Agreed, just a hair.

I'd still call it runnable though, even though I'd probly take the time to try .001 shallower :grinpimp:
 
1 - 10 of 10 Posts
Top