Pirate 4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter · #1 ·
Pardon me if this belongs in the newbie forum, but I'd rather ask the experts. The truck in question is a 79 Bronco with the dana 44HP front end.

I set out to replace my stock hubs this afternoon and came to a problem. After stripping out the stock hub and prying the axle outwards as far as it would go at the U-joint I could not properly seat the new inner hub (Warn Premium). No matter what I tried I was about 1/8" shy of the depth I needed to seat the snap ring. The really frustrating part was that I had clearly reached the point of interference, definate metal to metal contact. Is there some sort of a spacer deep inside there? Any other ideas?
 
1 - 2 of 2 Posts
Top