Pirate 4x4 banner

1 - 2 of 2 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter #1
I'm hooking an LS3 to an SM420 using the McLeod conversion flywheel and stock cast iron bellhousing. Because of room constraints, I wanna use an internal hydraulic throwout bearing. Anyone have experience using one with an SM420?

Sent from my SM-G960U using Tapatalk
 

·
Premium Member
Joined
·
815 Posts
I had one on an SM465. The pedal felt good, but I thing the release rate was wrong. I went through three throw-out bearings before I went to a Novak hydraulic kit. By the way, it's way fun pulling a million pounds of transmission and transfer case just to swap a hydraulic bearing
 
1 - 2 of 2 Posts
Top