Pirate 4x4 banner
1 - 2 of 2 Posts

· Registered
1,441 Posts
Discussion Starter · #1 ·
I got a power steering setup from a 74 f 100 with the hydrolic ram. I put the axle under my BII and ran performance steering with my stock box and pump (302) I was wondering if i could build up some mounts and use this ram instead of going out and buying a compleatly new one? Or is this one just junk and i shouldnt waste my time? I would get the box fitted by west texs offroad probly. so would i just have to run some High pressure hose down to it and i should work just like a normal ram. so i dont have to have that stupid sensor on the steering thats on the stock setup? Thanks
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.