[Colorado Cruiser]

Well, Im done with my atlas install...Almost. Last night all i needed to do was install my drive shafts and I could drive it. As it turns out the rear flage on my atlas is a non cv (1310) style instead of the cv style that I require. I ran out to my local 4x4 shop and got the cv style for the atlas, but the seal behind the flage is too big. After looking at the 2 flanges side by side, it appears as if the non cv flange has a larger exterior dia. than the cv flange. I guess I need a larger cv style flange or a larger seal. The Seal that is in the unit right now has a number SR 21164. Anybody have this problem before?

 

[RustyNailJustin]

Just looked at mine which has right now has 1350 no CV is the same as you 21164 Chicago rawhide. Someone over in General might know it right off hand. Or PM onetoncv Jess will know it.

 

[wngrog]

I got my 1410 from Jesse at High Angle.

 

[Eric]

Are you sure it is a 1310? The 1310 takes the smaller seal and the 1350/1410 takes the bigger seal. Maybe you took out a 1350 yoke and thought it was a 1310? I don't know the exact numbers, but the 1310 OD is about 1-7/8" and the 1350/1410 OD is about 2-1/8"

 

[EricFJ40]

For whatever reason the non-CV 1310 yokes use the 2 1/8 seal and the CV yoke uses the 1 7/8 seal. I know we have the part # for the seal you need at the shop, I'll try to remember to get it for you monday.

 

[Colorado Cruiser]

Im sure it is a 1310. Eric, I would be grateful if you could supply me with that seal #. Thanks everybody

 

[onetoncv]

part # 473239 national seal- sorry for the delay- jesse