Pirate 4x4 banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Does anyone know who makes a "dropped" idler arm and pitman arm for my 92 SR5 4Runner? I have the front up about 3 inches now with a combination ProComp shokz, Sway A Way T barz and shorter bump stops....but now the tie rods are at too steep of an angle. This will cause them to wear out qwik...or worse...
Any suggestions other than going to a solid axle....
Thanks
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top