[Wilson]

Basically, how do I hot wire my truck??? '93 toy V6

Earlier in the week, the column would not lock and the switch operated normally. Now, I got nothing at the switch (does not move) and the column is locked. I got all of the plugs pulled, and jumped the starter relay to pump the oil out of the two cylinders that were full (what a fawkin mess!) Now I look like a black spotted lepper and want to be able to scan the computer and hopefully try to fire the engine up (hoping the ecu did not get fried). I think If I pull the switch, I can get the column unlocked, so I can get the truck off the trailer. I need to know:

1. How to power up the ecu to run diag.
2. Jimmy it so I can try and start this thing

Thanks,
Jeremy

 

[gnob]

in the colum there should be a white wire and a white with red stripe. these are power to the switch,
the white needs to power the black/yellow, the blue/red.
the white/red needs to power the black/red

power to black is the starter
i also sent a pic of the diagram

 

[Wilson]

Thanks, did you email the diagram or ???

 

[Bigger Valves]

in the colum there should be a white wire and a white with red stripe. these are power to the switch,
the white needs to power the black/yellow, the blue/red.
the white/red needs to power the black/red

power to black is the starter
i also sent a pic of the diagram

hey you think i could get a picture of that diagram too?? i'm gonna be needin' this info.. thanks..
[email protected]

 

[gnob]

wilson,
i sent that to your regular email.
let me know if it helps and if you need more info

 

[Wilson]

Just got it and haven't checked it out yet. I'm going to play around with it in the morning... before the game starts.

Thanks again