Pirate 4x4 banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,444 Posts
Isnt it different for standard and CV. I have my flanges to drill this week and from what I gathered older and newer differences is just bolt hole size.

but I noticed standard shaft used a 4" flange and CV used a 5" flange. Now typically the CV shaft is only in the front of trucks.

So I got a spare from the front of a truck to use on the rear and have the one from my front. Just going to drill the larger size flange to accept the smaller flange bolt pattern and make sure the driveshafts are enlarged to use the larger bolts. Correct.

Reasoning for that is the larger flange size pattern wont fit on the smaller flange.

If you are doing it now myswell make sure you have the larger and drill for both.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top