Pirate 4x4 banner

1 - 6 of 6 Posts

·
Registered
Joined
·
89 Posts
Discussion Starter #1 (Edited)
I am about to start a rebuild and really like the overall width of 1 tons and H2 wheels ~80.25" out to out. I want to do the same thing but running full width Dana 44. I would use the 5 on 5.5 bolt pattern and was wondering if there are any common factory wheels that have a lot of back spacing that everyone uses to pull the track width in a little.
 

·
Registered
Joined
·
9,898 Posts
94-01 dodge half ton 4x4, came in 16's and 17's on the off-road package.
 

·
Registered
Joined
·
1,108 Posts
I dunno about the 16 and 17's but the aluminum 20's don't have enough meat around the lug nut pockets if you open the center bore big enough to fit a d44 hub through it... I measured
 
1 - 6 of 6 Posts
Top