Pirate 4x4 banner
1 - 1 of 1 Posts

·
Registered
Joined
·
575 Posts
I dont want to lop the whole damn knuckle off and thats what it feels like am about to do. HELP
Yeah, thats what you are about to do.........
You only have to go down the thickness of the axle housing. The knuckle ball is actually on a sleeve that fits into the axle tube, ands goes several inches past the weld into the axle tube....When you think you've gone thru the axle tube, its time to start twisting and pulling, I guess......

Someone who's already done this will probably pipe in on what you shuld do next.....
BUT IF YOU"VE GONE IN AS DEEP AS THE THICKNESS OF THE AXLE TUBE....STOP!!

Good Luck

[ 09-22-2001: Message edited by: Cracker ]
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top