Pirate 4x4 banner
1 - 2 of 2 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
I have the trunnion bearing eliminator kit with the wiper seal uprade. I just got done building a new housing and was wondering when measuring the knuckle pull, do i take the reading with the wiperseal backing plates off? Trail gear was not very specific but the measurements with the backing plates off is about 8 lbs. With the backing plates installed brings it up to 35 lbs. I know the specs are 15-25 and i have stacked a crapload of shims trying to bring the pull down.:confused:
Thanks in advance
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.