Pirate 4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
My rear Lower control arm rod end has pulled out from the tubing. (Jamb nut was tight) So now it's stripped out. It is a pretty heavy long arm from Terraflex (LCA).
Outside of replacing the one end and the tube does anyone have a fix to reccommend? I tried welding up three 5/16" holes drilled through the tube and into into the rod end (rosebudded) but it didn't hold after just one trail. Maybe I'm just not a very good welder either.

Any ideas??
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
Are you serious? JB Weld the threads or the jambnut to the tube end?
I used it before but never on something with this much force on it. You're kidding right?
 
1 - 2 of 2 Posts
Top