Pirate 4x4 banner

1 - 11 of 11 Posts

·
Registered
Joined
·
4,493 Posts
Discussion Starter #1
7/8s rod end, 3/4 hole. 1.75 wide. Wfo has them at 8 bucks a piece because they are stainless. Anyone know of any in zinc half that cost before I order from wfo?
 

·
Registered
Joined
·
3,953 Posts
Ruffstuff spacers are 2" mounting width. I use the 3/4"-5/8" misalignments in a 1.75" wide application on my link kits and I just turn 1/8" off each. This part might get confusing but they have a step out at the end which allows me to turn that 1/8" off without loosing any OD/contact area where they meet the mounting tab.
 

·
Vendor
Joined
·
3,519 Posts
Yep I had to do that for a truss as well. Crap now that I think about it those were Ruffstuff Heims, so they were definitely 2". Wasn't sure if the OP had access to a lathe or not, but here are pics



 
1 - 11 of 11 Posts
Top