Pirate 4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
7,442 Posts
There are shops to have that done, and I would keep looking. But if you insist on doing it yourself...

1. need access to specific modified S-record file that will suit your needs.

2. programmer (depending on the voltage of the device). A 3 volt device can be programmed with an EMP-30, which is rather expensive at Fry's Electronics. But, if the PROM is a 5 volt device, an EMP-20 can be used. I would check Ebay for this. The EMP-20 at Fry's last year was under 400.
 

·
Registered
Joined
·
7,442 Posts
Actually, if you have the ECU somewhere near you, pull the sticker off of the PROM and tell me the manufacturers part number and name. I can tell you what device it is and what voltage. I might be able to program it too. I have all the equipment. Just need the s-rec file.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top