[tmaddox4x4]

Shit canning the radius arms, going with single triangulated four link. I want to mount the lower links strait with the frame rails. Driver side is easy, pass side not so easy. What is the best way to mount the lower links on pass side. Should I remove some of the diff housing and weld on the tube? I am building a full truss on the top from C to C. Maybe put one tab on the tube and one on the cast? Any ideas or advice would be great. Chevy D60 housing.

 

[bbaxter51]

there's plenty of room to mount your lower link in there. I know the newer ford d60's get tight, but not sure about the newer chevs.

Here's mine I did with ballistic brackets. A pic of what your working with would help too.

 

[slowagon]

Check this out
http://pirate4x4.com/forum/showthread.php?t=830206
I'd like to see other options as well. I've got an older dynatrac 60 with about an inch of tube showing on the drivers side.

 

[bbaxter51]

Check this out
http://pirate4x4.com/forum/showthread.php?t=830206
I'd like to see other options as well. I've got an older dynatrac 60 with about an inch of tube showing on the drivers side.

That's a great build thread! That dude HOFF knows how to lay down a weld.