Pirate 4x4 banner

1 - 20 of 238 Posts

·
Registered
Joined
·
12,234 Posts
Discussion Starter #1
We can design many things and understand what you need and want , We have the capability of making 1 part or 200 , and take pride making your parts in the USA ! We have many lathes ,roughing, finishing and turret . We have cnc mills and run master cam for most of the programs . We have around 60 cutters for our broach that include dana 44 pinion + dana 300 26 spline , 1 1/8 10 spline dana 18 , dana 60 and 70 29 spline , 32 spline 205 and atlas outputs, Our new allison trans and Titan 34 spline , along with many more upon request.
High Angle Drivline-Call Jesse at 530-877-2875 and also on facebook @ High Angle Driveline 530-877-2875
 

Attachments

·
Registered
Joined
·
12,234 Posts
Discussion Starter #6 (Edited)
Mike I know I could do it -but we have to send them in to soften them , then get the cutter , and then resend them to be harden again. I could see doing 200 maybe ,mainly due to the way they need to be done .
 

·
Premium Member
Joined
·
1,466 Posts
Mike I know I could do it -but we have to send them in to soften them , then get the cutter , and then resend them to be harden again. I could see doing 200 maybe ,mainly due to the way they need to be done .
They are not that hard. I had mine broached without annealing/heat treat.
 

·
Registered
Joined
·
12,234 Posts
Discussion Starter #16
If there over 40 rockwell the cutter may work a few times , then it will break or dull out. And that's left on my shoulders .
 
1 - 20 of 238 Posts
Top