Pirate 4x4 banner
1 - 1 of 1 Posts

Premium Member
1,531 Posts
Discussion Starter · #1 ·
1. Kearney 2d mill. 480v runs good, a set of collets comes with it. No power feed or driving gears for a dividing head. 900 without step up transformer 1200 with transformer.

2. Buffalo no 0 iron worker. Converted to 220 single phase. It runs but needs some work. I have a few sets of punches, and a couple of new knives for the shear. It has shear, corner notcher, square notcher, angle shear, and punch. $1300

3. Monarch 10ee. Non running missing compound, has taper attachment tail stock, shows some wear on ways $1000.00

I can load up all machines. All machine need a little work. Machines are located in central wi.

You can contact me Ringleboy26 @ yahoo dotcom
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.