measuring for shock length

16577 Views 9 Replies 9 Participants Last post by billj, Jan 30, 2003

Joe_W

Discussion Starter · Jan 29, 2003

OK...1st of all I did search :flipoff2: Found some good stuff but wanted to just see if my thinking was flawed or not.

Now that the Samurai is finally soa'ed etc I want to measure for the correct length shocks...ie ones that won't limit my travel. Now for extension I figure I can just hi-lift the side of the truck up till the wheels come off ground, measure that and thats at least as long as I want the shocks to be, that all make sense so far?

Now my real question is with the opposite side be as compressed as it would ever want to go or would/could there be more compression available? I'm just not sure if meauring the low side will give me the correct short length.

thoughts, answers, flames???

Save

1 - 1 of 10 Posts

BossBuilt

· #9 · Jan 30, 2003 (Edited)

OK here is what I did for compression that worked for me.....
I popped a ball hitch in the rear reciever and connected a car trailer to it...
Then I drove a truck all the way forward on the trailer (Max tung weight)....this method is real safe...and works for the front too if you have reciever mounted up there..

Save

1 - 1 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month