Pirate 4x4 banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,386 Posts
Check the machine itself, not the torch. I'd think there is a gas selinoid before the torch wich turns the gas on or off when you strike. And a ball type gauge would be a good thing. There is also a ball type gas pressure tester . You snug this piece over the nozzle to see if you are getting the desired gas flow at the torch. Hard to tell if you dont know how much gas youre getting in the first place.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top