Mini CV on Cruiser

902 Views 6 Replies 4 Participants Last post by FeCamel, Oct 1, 2001

FeCamel

Discussion Starter · Sep 30, 2001

Hey everyone. I checked the archives, but I didn't really find solid info. With my SOA, OME springs, and long shackles the rear u-joints are binding at slight droop. I guess I'll have to go CV and rotate the pinion up. Do minitruck CVs match any LC bolt pattern at either the t-case or pinion? Is the splining the same, if so it would be possible to use the cv top and then the LC lower part so at least the pinion flanges match. I assume getting a used truck CV and having the length altered is the cheapest option here. Any other ideas? Thanks.

Save

1 - 1 of 7 Posts

crawlin cruiser

· #5 · Oct 1, 2001

I just used a mini truck CV d-shaft for my SOA it works really well. All you gotta do is get it lenthened and take a die grinder to the bolt holes. HTH!!

Dan

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month