[LukeZero]

I got my rear end from Jeremiah Proffitt at Proffitts Cruisers. Mini truck ends and axle shafts with LC center section. Centers the differential and loses the C-clips. There are also plenty o' chrome-moly aftermarket axle shafts for mini truck rear ends. So far, I'm happy with it, but that said, its only been sitting on jackstands, mocked up under the chassis. It sits there real nice. :flipoff2:

 

[LukeZero]

[QUOTE='62FJ40]LukeZero, what is this axel going to cost you?
Housing, axels ect... what else must be purchased to
make this set-up complete? calipers... brake lines...ect
strength wise how will it compare to a 9'' Ford or similar?
Thanks[/QUOTE]


Sorry, was out of town for the weekend.

Estimated costs...

$450 for housing.

$600 for ARB
$200 for gears
$150 for setup kit
$40 for pinion flange
$50 for some old axle shafts

Calipers, rotors, studs, hangers, etc.........$200.00

So... about $1700. But since you already own most of the stuff for the center section- you could get by a lot cheaper.

Hope this helps. Luke