Got that idea from a couple different people, but can't remember their names cause they are losers :flipoff2: . The bends ended up being a little different than you told me, but not by much. Thanks for the help Dan!!
Rear bumper is awesome. If you ever find time to post the pattern for that baby let me know. I ain't too proud to copy a good piece of work.
Here's to ya :beer:
No pattern for the bumper, just measured the distance of the rear end (I think it was 54"), it's a 2x4 1/8" thick, cut and angled the corners 4" back and 2" up, then measured the holes for the lights where it looked good. That's it in a nutshell . really just test fit it up there and cut the mounting plates based on that.
21 - 26 of 26 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!