[Ztec]

Ok i want to make my pro tools 105 bendor hydraulic with this bottle jack from harbor freight http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=36397. So if you can make any sense of my crude plans i wanted to know were the bottom of the bottle jack should pivot from so that its full strokes opens the bendor the whole way? Also if anyone has any better ideas for the "frame" should I make it a triangle the meets were the bendor arms pivot? Ive got plenty of 1/2x4 inch steel to use? thanks

 

[7938]

Lots O hydro bender talk here.........

http://www.pirate4x4.com/forum/showthread.php?s=&threadid=127764

 

[davids78bronco]

I'm going to be mounting my bender on the back bumper of my truck, and using a saginaw pump, a DCV and a ram I have in the garage, to make mine hydro. I'm broke, so it'll take awhile to finish, but it'll have QC, so I can pack it in a box when I'm not using it. Expensive parts will be getting the DCV, the hoses and steel lines(to run down the length of the 20ft frame) and a small resevoir

 

[OOP'S]

Jay did it, Check it out!!!!

http://www.mindspring.com/~jayk5/bender/