Pirate 4x4 banner

1 - 7 of 7 Posts

·
Registered
Joined
·
2,782 Posts
Discussion Starter #1
I've got a 90" long section of seamless pipe that I need to have turned to get the ID concentric all the way through to remove the standard ovality. It's 316 ss, 16" od, .375" wall thickness, 90" long. Can anyone here do that?

PM me.
Thanks!
 

·
Registered
Joined
·
2,782 Posts
Discussion Starter #4
Yeah, I've got some places that can do it, they are specialty shops for hyd. cylinders and such...heck the material alone for this piece 2 years ago was $9000.00....I'm getting quotes of ~$14,000 for the matl. alone!!! Doesn't really matter....just need to get it done.
 

·
Registered
Joined
·
2,782 Posts
Discussion Starter #5
A low pressure hyd. cylinder basically....think of a floating piston, no rod, just to seperate two fluids. The piston floats to allow fluid level changes of each fluid...make sense?
 

·
Registered
Joined
·
2,782 Posts
Discussion Starter #7
Thanks, I got it sourced. Carlson Tool can do up to 12" ID.
 
1 - 7 of 7 Posts
Top