Pirate 4x4 banner

1 - 7 of 7 Posts

·
Registered
Joined
·
2,023 Posts
Discussion Starter #1
Does anybody know of a yoke that matches the 1 1/8" 10 spline GM input shaft?

How about any yoke that goes on a 1 1/8" pinion shaft (or even slightly smaller)?

[ 09-18-2001: Message edited by: Reddwarf ]
 

·
Registered
Joined
·
12,238 Posts
THE GM 205 early case front out put was an 1 1/4 10 spline and goofie - as far as i know its uses were only 1310 c/v or non c/v with special u bolts- as far as smaller what are you doing or looking for exactly? i might be able to help if i know - JEss

[ 09-18-2001: Message edited by: onetoncv ]
 

·
Registered
Joined
·
2,023 Posts
Discussion Starter #3
I want to put the yoke on the front of a GM NP 435 to use it as a "divorced crawl box".

Just looking for cheap extra-low reduction. <IMG SRC="smilies/cool.gif" border="0">
 

·
Registered
Joined
·
12,238 Posts
i beleive that there is a 1350 series end yoke that will bolt on you just have to tap the end of the shaft- what exact spline ? and major dimension- ? and what ties do you have to dana corp? Jess

[ 09-18-2001: Message edited by: onetoncv ]
 

·
Registered
Joined
·
2,023 Posts
Discussion Starter #5
No ties to Dana, just got tired of having <IMG SRC="smilies/cool.gif" border="0"> as my picture.

Not sure exactly how to measure the splines, but they're square-cut. It's the standard GM truck input shaft if that helps.

Where can I find this 1350 yoke you speak of?
Is something smaller available? It will be behind a small 4 cylinder manual trans (about 3.5:1 first).
 

·
Registered
Joined
·
3,620 Posts
You should be able to get a 1350 yoke from any Dana/Spicer dealer. Or you could just call Jess and get it through him. I'm sure he could customize the 1350 yoke for you.

Disclaimer: not associated with High Angle driveline... Just a customer...

Charles
 
1 - 7 of 7 Posts
Top