Pirate 4x4 banner
1 - 8 of 8 Posts

· Registered
Joined
·
152 Posts
Discussion Starter · #1 ·
i got a new set up from north west fab. when i hit about 40 the cases start making nose and will not go away un til i stop or if i put the 205 in nutral. put new bearings in the 203 and have look at the 205 and see nothing wrong. got any ideas to help me figure this out.
 

· Registered
Joined
·
215 Posts
mines from ord and its kinda loud if i get going then let off on power it will make noise until i give it gas then it goes away. but my buddys does the same so i didnt worry
 

· Registered
Joined
·
6,459 Posts
what range are the transfers in? when my 203 range box is in low range and i'm doing a higher rate of speed there is a gear whine, but this is normal.
 

· Registered
Joined
·
152 Posts
Discussion Starter · #8 ·
Very likely that it's a driveline vibration even if you can't feel it, the gear driven transfer cases tend to be noisy with a driveshaft that isn't quite vibration free.
Hey thanks man. I throw my buddy's brand new drive line in that just so happens to be the same langth and it sound great. Guess I'm off to the drive line shop next week. Thanks again.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top