Pirate 4x4 banner

NEW - Ruff Stuff weld on rear axle flanges - SOLD

1K views 3 replies 2 participants last post by  jon84cj 
#1 · (Edited)
These are the flanges that allow you to run Dana 60 front spindles and hubs on a rear axle. They are drilled for Chevy and Ford spindles so you could use either. You use front axle caliper brackets as well. Brand new just a bit of surface rust. These are discontinued and getting harder to find. 3" inside diameter that you can bore to fit.

SOLD
 

Attachments

See less See more
4
You have insufficient privileges to reply here.
Top